5
Safety and Warranty
FOR YOUR SAFETY
1.
Do not store or use gasoline or other flammable substances in the vicinity of this or any other appliance.
2. An LP cylinder not connected for use shall not be stored in the vicinity of this or any other appliance.
Warning: For outdoor use only.
Warning: Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Read the installation, operation and maintenance instructions thoroughly before
installating or servicing this equipment.
•
This appliance must be installed and the gas cylinder stored in accordance with the regulations in force.
•
Do not obstruct the ventilation holes of the cylinder housing.
•
Do not move the appliance when in operation.
• Shut off the valve at the gas cylinder or the regulator before moving the appliance.
• The tubing or the flexible hose must be changed within the prescribed intervals.
• Use only the type of gas and the type of cylinder specified by the manufacturer. The LP tank used with your
patio heater must meet the following requirements:
Purchase LP tanks only with these required measurements: 31.8cm (Dia.) x 58cm (tall) with 15kg.
maximum capacity.
•
In case of violent wind particular attention must be taken against tilting of the appliance, keep the appliance
at least 1m from the gas cylinder.
•
The injector is installed by the manufacturer only. Do not connect the gas cylinder directly to the appliance
without regulator. Use only the type of gas and cylinder specified in the instructions.
CAUTION
•
Do not use the patio heater indoors.
•
This outdoor heater is not intended to be installed on recreational vehicles or boats.
• Installation and repair should be done by a qualified service technician.
•
Do not attempt to alter the unit in any manner.
•
Never replace or substitute the regulator with any 3rd party replacement. Only use the original parts.
•
The whole gas system, hose, regulator, pilot or burner should be inspected for leaks or damage before use,
and at least annually by a qualified technician.
• All leak tests should be done with a soap solution. Never use an open flame to check for leaks.
•
Do not use the heater until all connections have been tested for leaks.
• Turn off the gas immediately if you can smell gas.
•
Do not transport the heater during operation.
•
Ensure the heater is fully cooled before moving.
•
Keep the ventilation opening clear of all debris.
•
Do not paint any part of the unit.
• Frequently clean all air passageways and the burners.
•
Close the valves when not in use.
•
Check the heater immediately if any of the following occur:
- The heater does not reach temperature.
- The burner makes a popping sound during use (this noise in normal only when turning off the burner).
- Smell of gas in conjunction with extreme yellow tipping of the flames.
