6
Operation
Technical Specifications
1. Before use, check whether the power supply corresponds to that required by the machine, check whether
the external earthed wire is reliably connected.
2. The machine which 3 phase motor must be checked whether the machine rotates in the direction indicated
by the rotation mark. If the rotation direction is wrong, exchange the two of the three livewires each other.
Note: For test of machine, mixing tools should never be installed, otherwise they would fall out in order to
avoid damage to machine parts because of wrong rotation direction.
3. Select speed and agitator:
a) Spiral agitator: It is suitable for mixing dough and sticky solid food, the weight of flour must refer to the
mark, the capacity of water is 47%~50% of the flour’s, and the machine is available for low speed.
b) Vaned disk agitator: It is suitable for thin pieces, powdered and mushy food, like stuffing, and available
for middle speed.
c) Beater: It is suitable for cream and eggs beating, and available for high speed.
Caution: Stop the machine to change speed, do not mix dough at middle or high speed.
4. Speed changing operation: B60 has an adapted motor and mechanism’s concerted action to change
speed. The speed changing operation and mixer instruction must refer to the illustration below:
5. Bowl lift: The Bowl is driven by motor to raise or descend up to the requested position(top point, bottom
point, and stop point). The operating method is:
- Adjust the lifting handle to 458 comparing the horizontal line, and then raise the bowl.
- Adjust the lifting handle to the horizontal line, and then descend the bowl.
- When the lifting handle is between the two positions, the bowl will stop lifting.
Note: When assembling an agitator, in order to avoid falling, the backing pin on the mixing shaft must
slip into the L-shaped slot on the agitator.
6. M60 Mixer is equipped with timer, so you can select the timer control as needed. If you use the timer, you
can set the needed time on the timer.
Model
MX-CN-0060-U
Power
3 - 3.75 HP / 2.24 - 2.8 kW
Mixing RPM
79 | 109 | 143 | 216
Capacity
56.8 L / 60 QT
Kneading Capacity
44 lbs. / 20 kgs.
Electrical
220V / 60Hz / 3Ph
Dimensions
24.4” x 40.4” x 56.3” / 620 x 1026 x 1430mm
Weight
1078 lbs. / 489 kgs.
Item Number
19999
