6
Technical Specifications
Installation
The juice extractor must be installed on a flat, non-skid work surface with a maximum recommended height
of 85cm. This equipment is equipped with a three pin electric cable. All pins must be connected before
the machine is turned on. This ensures the machine is properly grounded. Check if the machine voltage
corresponds with the power source.
Model
JE-BR-1750-Q
Power
0.25 HP / 0.19 kW
RPM
1750
Electrical
110V / 60Hz / 1
Weight
12 lbs. / 5 kgs.
Packaging Weight
13 lbs. / 6 kgs.
Dimensions
7.6” x 7.6” x 15.25” / 193 x 193 x 387mm
Packaging Dimensions
8.75” x 14.5” x 15.6” / 222 x 368 x 396mm
Item Number
46957
Operation
PRE-OPERATION
Check if the machine is stable and that there is no movement on the supporting surface. Wash all food contact
parts with hot water and neutral soap. Check if crown is properly fitted. Place sieve inside the juice vessel and
put it below output opening. The extractor is now ready to operate.
IMPORTANT
Always disconnect the unit from power source before changing the crown. Place the crown on motor shaft and
make sure it is properly fitted. To start operating, press the black push-button switch to the ON position. How to
feed the machine:
1. The juice extractors work very quickly, therefore they should be equally fed.
2.
First of all cut fruit in two halves. With one hand, hold the cut fruit and press it down firmly against the
crown.
3. The juice will flow to the vessel through the chamber and the sieve.