18
Maintenance
Troubleshooting
2. Remove all ice cubes from the storage bin.
3. Remove the screws in the front cover, push forward to remove the front cover. Locate the control box.
4. Prepare a sanitizing solution by mixing 1 oz. household bleach with 1 gallon of warm water.
5. Keep the ice maker connected to the water supply. Fill the water tank with the sanitizing solution.
6. Turn the power switch ON. Within 3 minutes, press the CLEAN button. The machine will run the Automatic
Clean mode. The yellow Ice Harvest and the red Bin Full LEDs will blink.
7. The cleaning cycle will continue for 30 minutes unless you press the power switch (you can press the
power switch to stop the cleaning cycle any time during the 30 minutes). After cleaning, the yellow Ice
Harvest and the green Ice Making LEDs go on steady and the machine returns to Stand-by mode.
8. The dirty water must be drained out completely. Perform steps 2 and 3 in the Interior Cleaning section.
9. Repeat steps 5 to 8 above three times with fresh water to rinse the ice-making system completely.
NOTE: Do not add any cleaning or sanitizing solution to the water trough during the rinses.
10. Reassemble the front cover.
11. If you want to make ice cubes after cleaning, turn off the power switch, drain off the waste water, then turn
on the power switch. The next ice-making cycle will begin.
12.
Discard the first batch of ice.
BEFORE CALLING FOR SERVICE
If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the
problem persists, check the TROUBLESHOOTING GUIDE on the following pages. The problem could be
something very simple which can be solved without a service call.
