9
Operation
Maintenance
HOW TO USE
Allow to stand for a minimum of 4 hours before plugging in to the mains.
The temperature is controlled by the temperature control knob located on the front face, at the bottom right
hand side. Rotate the control knob left or right to regulate the temperature inside the freezer.
1.
When initial operation, the freezer should run emptily about one hour before storing food in it.
2. The thermostat could adjust the temperature inside the freezer. When you turn the knob in clockwise. The
bigger the figure, the lower the temperature. Generally, the position of ‘4’ is suitable, around 0°F. At “Max/7/
HI” position, the compressor will run constantly to reach the coldest temperature as quickly as possible
without stop (no cycle). Turn the temperature control to the “4” or “5” when temperature inside is stable for
ice cream and similar products.
INDICATOR LIGHTS
•
Power: indicates the freezer is switched on.
•
Run: indicates the compressor is working.
FOOD STORAGE
• Do not fill the freezer full of products. You should leave space between items and the inner surface of the
cabinet, so as to keep good ventilation of cold air and freeze evenly. Do not put in any bottled or canned
beverage with freezing point above the temperature in the cabinet when it is below zero.
•
For foods that should be moisture-free or lose water easily, wrap them up with hermetical food bags or
fresh films before putting in the cabinet for the sake of avoiding smell-mixing and reducing frosting.
• Storage of volatile and combustible gases, liquids such as strong alkalies, strong acids, petrol ,etc. is
forbidden.
•
Never put hot food directly in the freezer. Food should be cold or frozen before placing it inside.
•
The cabinet is intended exclusively for the storage and/or display of packaged foods only.
• The freezer should be cleaned regularly. When cleaning, turn off the power, take out the foods in the
cabinet, clean the inside using water or a little neutral detergent.
•
Do not use boiling water, acid, chemical diluent, petrol and oil, or dirt removing powder.
•
Dry it after cleaning.
•
Use light soap water when cleaning the door seal, apply a little of talcum powder on it after natural drying to
extend its service life.
•
Use soft cloth with water or a little detergent to clean the out surface.
Note: keeping the power supply and lower part of connect wires away from water to avoid
electricity leakage.
• Except common breakdowns, those who are not service technician should not take apart and repair the
