6
Installation
Operation
Connect the machine to an electrical socket which has the same voltage rating as the machine. The machine
should be placed on a countertop or table which is about 650 mm (26”) high. Locate the optional hanger (7A)
for the cutting tools (3) on a wall in the vicinity of the machine for convenient and safe use. Check the following:
discs (3) and ejector plate (2B) is fitted to the machine so that the shaft rotates clockwise. The machine cannot
be started without the flexi-feeder (8F) or feed hopper (1D) including the pusher plate (1A) fitted. The machine
stops when the feed plunger (8A) of the flexi-feeder is swung to the side so that the flexi-feeder opening (8B)
is larger than 45 mm. If the machine does not operate correctly, call Omcan for assistance with the problem
before using the machine again.
CHOOSING THE RIGHT CUTTING TOOLS
For dicing, the dimensions of the dicing grid (3G) should be equal to or larger than the dimensions of the slicing
tool (3A or D).
Standard slicer (3A): Slices firm materials, dices in combination with type 1 dicing grid (3G).
Dicing cutter (3B): Dices in combination with type 1 dicing grid (3G1) from 12.5×12.5mm upwards.
Ripple Slicer (3C): Produces rippled slices.
Fine Cut Slicer, 1 Knife (3D1): Slicers firm, soft, juicy and delicate foods. Shreds lettuce. 44 mm chops
of onion. In combination with type 1 dicing grid (3G1) 10×10mm and upwards. 4.6 and 10mm dices in
combination with type 2 dicing grid (3G2).
Shredder (3F): Shreds and cuts curved potato chips.
Type 1 Dicing Grid (3G1): Dices in combination with suitable slicer. Cannot be combined with 14 mm Fine Cut
Slicer. See type 2 Dicing Grid below.
Type 2 Dicing Grid (3G2): Dices in combination with 14 mm Fine Cut Slicer.
Raw Food Grater (3H): Cuts straight potato chips in combination with 10 mm Fine Cut Slicer.
Raw Food Grate (3K): Grates carrots, cabbage, nuts, cheese, dry bread, etc.
Fine Grater (3L): Fine grates raw potatoes, hard/dry cheese.
FITTING AND REMOVING THE CUTTING TOOLS
When fitting the tools, place the ejector plate (2B) on the shaft and turn/press down the ejector plate into
