8
Maintenance
CLEANING
It is important for the machine and its accessories be kept clean after using.
• Unplug the coffee maker and allow to cool.
• Wipe all external surfaces including the hotplate with a damp cloth and dry thoroughly.
• The glass jug, pots and filter basket should be washed in warm soapy water than rinse and dry all parts
thoroughly.
No parts are suitable for cleaning in a dishwasher.
Never use harsh or abrasive cleaners.
DE-SEDIMENTS
If you operate in a hard water area, we recommend to de-scaling at regular intervals, e.g. every 2-3 months or
as required.
If the brewing cycle takes time longer than usual, or the steam condition is bigger than normally, it is a signal
that de-scale is necessary.
• Add 300 ml fresh lemon juice or condensed lemon juice to 1 liter of warm water (below 50°C).
• Slide filter pan and place an empty decanter or receptacles at the correct position under the filter pan.
• Pour solution of lemon juice into water reservoir and turn the switch ON.
• Some of hot water will drop into the decanter or receptacles until the solution of lemon juice push out the
waters remained in the machine. When there are some solutions of lemon juice drop into the decanter or
receptacles, then turn the switch OFF.
• Wait for 5~6 minutes to enable the rest of solution to run through with sediments, then turn the switch ON
again.
• When the indicator lights off, set switch OFF and flush the solution away.
• Since some solution will still remain in the machine, we must run brewing process several times, until there
is no more smell of lemon juice in the hot water which flow out from the machine.
• The machine is ready for service again.
Failure to de-scale will invalidate your guarantee.
RE-SETTING
In case, if the brew cycle fails to operate switch the appliance off and unplug
from the power supply. Remove the rear cover and check to see if you can
press the button down on the side of the boiler. If the button presses down
and clicks, then descale the unit before next operation. If problem persists,
then contact Omcan.
Summary of Contents for CM-CN-0002-D
