10
Installation
Operation
LEAK TESTING THE REGULATOR, VALVES, HOSES, AND CONNECTIONS
1.
Ensure the LP cylinder valve and all burners are “Off”.
2.
Ensure the LP cylinder is connected to the regulator.
3.
If the information in 1 & 2 is not followed exactly, a fire causing death or serious injury may occur.
4.
Mix a solution of 50% water and 50% liquid dish soap. Do not use any household cleaning solution.
5. Open the LP tank valve by turning the hand wheel counterclockwise one turn. If you hear a rushing sound,
turn the gas off immediately. In that case, there could be a leak at the connection. Reconnect the cylinder
to the regulator.
6. Spray or brush on the solution covering the following areas: regulator and cylinder connection, gas hose
connections to the regulator, all gas hoses, all gas hose connections to the burners, including the main and
side burners.
7. Growing bubbles on any of the parts and connections listed above indicate a gas leak. Immediately shut off
the LP tank valve by turning the valve clockwise. Re-tighten the connections or order replacement parts as
needed. Continue to test as necessary until no leaks are detected.
8. Close the LP tank valve by turning the hand wheel clockwise.
WARNING
1.
DO NOT USE THE GRILL if you cannot stop the leaks. Be sure the LP cylinder valve is closed. If the LP
cylinder is still leaking, contact your LP dealer or local fire department.
2.
Do not use any match or open flame, or smoke, during leak testing.
3. Do not light a burner during leak testing.
4.
The replacement hose assembly must be the one identified.
FOR YOUR SAFETY
1.
Minimum clearances from sides; 12” / 30cm, and back; 24” / 61cm.
2. Do not locate this outdoor cooking gas appliance under overhead-unprotected combustible surfaces.
LIGHTING
Always visually inspect your grill before lighting. Replace any hoses that are frayed or cracked before lighting
your grill. Look for anything that may be blocking spaces for ventilation and remove. After lighting, always
check the flame to ensure you have a good flame all along each burner. If not able to light, or the flame is not
even along the entire burner(s), then see the Trouble Shooting.
WARNING
1. Read instructions before lighting.
2.
If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes and repeat the lighting
procedure.
