Omcan 49115, Instruction Manual, Page: 10 / 28

10
Installation
Operation
specialised and expert technicians, in possession of the technical and regulatory knowledge for executing the
work safely in accordance with best industrial practice and in conformity with the standards in force; they must
issue any conformity declarations envisaged by the law. On delivery of the machine and in any case before
proceeding with the electrical connection check that the voltage, frequency and number of electrical phases
corresponds to the manufacturer’s indications on the ID plate and in the electrical schematics.
The machine is supplied complete with:
• Cable with three-phase conductors and one ground for the three-phase power supply.
• A cable with a line conductor, a neutral one and an ground one, for the single-phase supply, but without a
plug at the end: the latter must be procured and wired by the users (the job should be done by an expert
electrician) on the basis of the sockets available and which in any case must obviously be suitable for the
number of poles and power requested (see the attached wiring plan).
When connecting the connectors, remember that the earth conductor must be connected to the terminal
corresponding to the pole with greatest length and diameter. Check the correct rotation direction of the motor
when the connections have been made: the movement of the belts must be consistent with the start command
and motion inversion device; if it is not, swap around two phase conductors (take care not to invert a phase
conductor and the ground one). Use the special ground system: its efficiency must be checked periodically. Do
not connect to gas or water pipes or other metal structures. The supply cable must be kept at a distance from
parts that are hot or in movement and must not impede the passage of persons, animals or things. The plug
must remain easy to access and well in sight at all times.
The use of the machine must be reserved exclusively for expert and authorised, trained and instructed persons
who have also been informed of the typical risks and how to eliminate or reduce them. The machine must be
used by only one operator at a time, in conformity with the envisaged and declared use; no operations on/
with the machine are allowed by more than one operator at the same time with the exception of the cases
envisaged in this manual (e.g. assembly/disassembly of a worktable). The manufacturer can supply the
necessary training following agreement, while it remains understood that the user is responsible for:
• Identifying the most appropriate persons to use the machine.
• Ensuring that they obtain the necessary training and instruction (also practical).
• Implementing appropriate procedures for reducing exposure to the residual risks that the use of the
machine entail.
ATTENTION! It is forbidden for persons who are not in possession of the requirements required and
indicated herein to perform operations on and/or with the machine.
The manufacturer declines all responsibility for damage to persons, animals or property caused directly or
indirectly by failure to observe the instructions in this manual.