6
Installation
carry, store and handle the unit in a vertical position and follow the instructions found on the packaging.
2.
If the unit was placed in a non-vertical position during the transportation, keep the unit in a vertical position
for approximately 24 hours before using the unit and turning it on, to allow the oil to flow back into the
compressor.
UNPACKING
1.
Remove the wooden baseboard and plastic covering.
2. Make sure that the unit has not been damaged.
3. Remove plastic film from all the stainless-steel panels, if applicable.
IMPORTANT: The packaging should be kept away from children as it is potentially dangerous. Dispose
of the packaging according to the regulation from the local authorities.
POSITION
1.
Never clean the unit with pressurized water jets.
2.
Place the unit on a flat and stable surface.
3.
Install the unit in a location where it can be overseen by trained personnel.
4.
For good ventilation, keep 20 cm (7 inches) between the unit and walls or other objects. Increase the
distance if the objects surrounding are heating sources. When the unit is in place, press the brake on the
wheels to keep it from moving.
5. Fix the shelves on the unit.
ELECTRICAL CONNECTION
Before inserting the plug into the electrical socket, carefully read the following precautions:
1.
Make sure that the unit is correctly connected to a properly grounded outlet, in compliance with current
safety standards.
2. Make sure that the voltage is in accordance with what is indicated on the rating label.
3. The current voltage available should be enough for the maximum energy required by the unit.
4. If necessary, use multiple outlets, which are all properly grounded, in compliance with current safety
standards.
5. If in doubt, please consult qualified technicians.
THE REFRIGERATED SHOWCASE MUST BE CONNECTED TO AN ELECTRICAL SOCKET WITH A
GROUND.
Operation
Before using, the unit should be completely cleaned as it comes into contact with food.
1. Make sure that the main switch is in the (I) position, then plug in the unit.
2. Before starting the unit, ensure the sliding doors are properly closed.
3. Turn the main switch to the (I) position, the condensing unit will automatically start.
