Omcan 37525, Instruction Manual

Page: 5 / 20

5
Technical Specifications
Installation
Model # of Burners Temperature Range Dimensions (mm) Item #
TH-RB-1 1 50~300°C 455×532×620 37525
TH-RB-2A 2 50~300°C 455×1064×620 37529
These kinds of gas stoves can be operated by LPG or Natural gas. You may replace the nozzles. But please
contact Omcan for details of diameter of nozzles. The nozzles are included with the stove or can be ordered
from manufacturer. The slightest difference in diameter would influence the performance of the burners.
INSTALLATION TO BE DONE BY LICENSED PROFESSIONALS ONLY.
SET UP
1. Remove all packing material and tape, as well as any protective plastic from the equipment.
2. Place the equipment in the desired position and height.
3. Install the four (4) legs onto the equipment.
4. Clean and dry the equipment thoroughly before using.
INSTALLATION
The installation of this equipment must conform with local codes, or with the National Gas Code, ANSIZ223.1/
NFPA 54, or the Natural Gas and Propane Installation Code, CSA B149.1, as applicable.
• The equipment and its individual shutoff valve must be disconnected from the gas supply piping system
during any pressure testing of that system at test pressures in excess of ½ psi (3.5 kPa).
• The equipment must be isolated from the gas supply piping system by closing its individual manual shutoff
valve during any pressure testing of the gas supply piping system at test pressures equal to or less then ½
psi (3.5 kPa).
CLEARANCE AND POSITIONING AROUND EQUIPMENT
• This equipment must be installed adjacent to non-combustible surfaces only with a minimum spacing of 6”
from all sides. This equipment must be a distance of 6” from other equipment. The equipment must have
the 4” legs installed and be placed on a non-combustible surface.
AIR SUPPLY AND VENTILATION
• The area in front and around the equipment must be kept clear to avoid any obstruction of the flow of
combustion and ventilation air.
• Adequate clearance must be maintained at all times in front of and at the sides of the equipment for
servicing and proper ventilation.