14
Troubleshooting
The table below indicates the most common problems that may arise during slicing and the necessary
remedies.
PROBLEM
POSSIBLE CAUSE
REMEDY
The machine does not start when
the white or green button is
pressed
No power supply
Ascertain that the plug is correctly
inserted
The blade guard is not correctly
positioned
Check
Defective electrical control circuit
Call technical assistance
When the switch is turned or
when the white or green button is
pressed, the machine starts, but
the white functioning light is not on
Defective indicator
Do not use the machine when the
pilot lamp is not on; Call technical
assistance
The machine starts, but there are
vibrations. The motor is very hot
and there is a bad smell
Defective motor or transmission
Do no use the machine, call
technical assistance
Under strain, the machine slows
down or comes to a stop
Defective transmission
Call technical assistance
Excessive resistance to product
slicing
The blade is blunt
Sharpen the blade
The slices are ragged and/or
shaped irregularly
The blade is blunt
Sharpen the blade
The blade is excessively worn out
Call technical assistance
Unsatisfactory blade sharpening
Worn wheels
Replace the wheels; call technical
assistance
The product tray does not slide
Guides are insufficiently lubricated
Lubricate
When the switch is turned or when
the black or red button is pressed,
the machine does not stop
Defective electrical control circuit
Stop the machine, unplug from
mains and call technical assistance
DISMANTLING THE SLICER
These machines are made of the following elements:
•
Aluminium frame;
• Stainless steel fittings and others;
•
Electrical parts and cords;
•
Electrical motor;
• Plastic materials, etc.
Whether dismantling is entrusted to third parties or done in-house (in that last case you will have to separate
the various materials) please note that disposal of the materials can only be carried out by duly authorized
businesses. In any case, please comply to the current norms of your country.
