400715D-EN
8
Videos
Videos associated with these instructions are located at
.
l
A-Jet Nozzle Removal and Installation
OMAX
l
Preparing for Maintenance of your
l
MAXIEM
l
Preparing for Maintenance of your MAXIEM Equipment
l
DOCUMENT SCOPE
This document contains the following instructions for the MAXJET 5i nozzle assembly and inlet body filter assemblies
on an A-Jet, Tilt-A-Jet, or Motorized Z-Axis installed on an OMAX or MAXIEM Abrasive Waterjet Systems.
OVERVIEW
The MAXJET 5i nozzle assembly has a 500-hour warranty (prorated for use) when installed, operated, and maintained
using the correct procedures. The integrated nozzle assembly's diamond orifice and carbide disc are factory aligned
and permanently installed inside the nozzle to produce an accurate jet stream while cutting. There are two styles of
nozzle, nozzle with abrasive tubing
retention tube
[1] or nozzle with abrasive
inlet
[2] (Figure 1). The style used is
dependent on nozzle availability and equipment. Both nozzles operate the same.
Replace the nozzle assembly after 500 or more hours of operation and the water jet stream quality degrades. Speak
with
when the water jet stream quality degrades prematurely (less than 500 hours of operation).
NOTICE
Do not disassemble the MAXJET 5i nozzle body. The nozzle body components are factory assembled and
aligned. Disassembling the nozzle body can damage the nozzle body and voids the warranty.
Handle the nozzle body with care to prevent damage to the abrasive tubing retention tube [1].
Figure 1
Summary of Contents for MAXJET 5i 305617 Series
Page 32: ...32 400715D EN...
