Siemens V20_EN_rev01-08032019.docx
9-6
“Fxxx”
Parameter value in hex format
“Axxx”
Alarm code
“Cnxxx”
Settable connection macro
“-Cnxxx”
Current selected connection macro
“APxxx”
Settable application macro
“-APxxx”
Current selected application macro
9.2.5
LED warnings
The SINAMICS V20 has only one LED for status indications. The LED can display orange, green, or red.
For example, if there is an active fault when the inverter is in the commissioning mode, the LED flashes
green at 0.5 Hz.
9.3
QUICK COMMISSIONING
9.3.1
Quick commissioning through the Setup menu
Structure of the setup menu
The setup menu guides you through the steps required for quick commissioning of the inverter system. It
consists of the following four sub-menus:
Sub-menu
Functionality
1
Motor data
Sets nominal motor parameters for quick commissioning
2
Connection macro selection
Sets macros required for standard wiring arrangements
3
Application macro selection
Sets macros required for certain common applications
4
Common parameter selection
Sets parameters required for inverter performance optimization
