ASSEMBLY
ASSEMBLY
05
05
13
14
Coupling
screw
Coupling
Hairpin clip
Clevis pin
Downrod
Pin
Canopy
Canopy cover
Downrod
stand cover
01
Turn OFF the electric circuit at the
main fuse of circuit breaker box.
Remove the hanger ball portion from the downrod/hanger ball assembly by loosening
the set screw in the hanger ball until the ball falls freely down the downrod. Remove
the pin from the downrod, then remove the hanger ball. Retain the pin and hanger ball
for reinstallation.
Remove the hairpin clip and clevis pin from the bottom of the downrod. Retain the pin
and clip for reinstallation for next step.
03
Spring
washer
Outlet
box
Mounting
bracket
Outlet box
screw
Securely attach the mounting
bracket to an outlet box marked
“ACCEPTABLE FOR FAN SUPPORT”
using the supplied outlet box
screws with spring washers.
02
04
Loosen the two coupling screws
preassembled in coupling, but do
not remove them.
05
Align the hole on downrod to hole on coupling,
then reinstall clevis pin.
Reattach hairpin clip
into clevis pin until it snaps into place, then
tighten the two previously loosened
coupling screws.
Coupling
screw
Downrod
Hairpin clip
Clevis pin
Coupling
06
Thread the motor wires and cable wire through the downrod stand cover, canopy
cover and canopy.