Page 22 of 76
Issue 20 : July 2012
WM--P1 SERIES WORKSTATIONS
6.9
Top Tray replacement WM- WP1
(1)
Remove all equipment from the top tray (item 14)
(2)
Refer to Section 6.7 and remove the Remote switch assembly and cable (item 2) from the top tray.
(3)
Refer to Figure 6-6. Using a 6mm allen key unscrew six screws (item 75) with washer crinkle (item 49) and
washer (item 45).
(4)
Remove and invert the top tray. Using a 6mm allen key relaese four screws (item28) with washer (item 50) and crinkle
washer (item 45). Separate the Top tray (item 14) from Support top tray wide (item 15).
(5)
Reassemble in reverse order. Secure top tray (item 14) to Top tray support wide (item 15) using a 6mm allen key to
fasten four screws (item 28) with washer (item 50) and crinkle washer (item 47) Do not fully tighten.
(6)
Place top tray assembly into place between the side columns. Using 6mm hex drive tool in torque wrench tighten six
screws (item 75) with washer crinkle (item 49) and washer (item 45) to 20Nm.
(7)
Fully tighten four screws (item 28) securing support toptray narrow to top tray using 6mm hex drive tool in torque wrench
to 4Nm
(8)
Refer to section 6.7 to refit remote switch.
42
2 2Nm
34
2
32
2
15
FIGURE 6-6
WM--WP1 REMOTE SWITCH & TOP
TRAY REPLACEMENT
78
4
77
4 2.2Nm
49
6
45
6
75
6 20Nm
47
4
50
4
38
4 4Nm
2
50
2
40
2 2Nm
14