EN 19
En
How to attach the camera table to the digital camera
In order to load the camera into the Case, attach the camera table (located on the front-lid side of the
Case) to the digital camera.
Using the UFL-2 underwater electronic flash with the underwater
optical fiber cable
1
Set the RC mode of the camera to ON so that the camera’s built-in flash is activated.
2
Load the camera in the Case with the camera’s built-in flash popped up.
Refer to the UFL-2 instruction manual for the UFL-2 operation.
1
The eyecup and the hot shoe cover of the digital
camera can be stored in the camera table.
2
Attach the camera table to the tripod seat section on
the bottom of the digital camera. Use the camera’s
tripod screw hole for attaching.
3
The camera table has fixed up-down and front-rear
orientations. To ensure that it is properly attached,
refer to the illustration on the right.
Up
Down
Front
Rear
PT-E05_EN.Book Page 19 Wednesday, June 4, 2008 12:34 PM
