E-6
After shooting, remove the inserted cam-
era and lens, then re-seal the empty
case and immerse it in tap water to
remove any salt as soon as possible.
5
Maintenance
For safe use of this product, always perform maintenance after each diving session.
For details, refer to “Handling After Shooting” and “Maintaining the Waterproof Function” in the PT-E series
case instruction manual. Apply the same procedures to this product.
Insert the O-ring remover between the
O-ring and O-ring groove so that the tip
of the O-ring remover slides under the
O-ring (take care not to damage the
groove with the tip of the O-ring remover).
When the O-ring is raised, pinch it with
your fingers and separate it from the case.
If any foreign matter is attached to the
O-ring grooves, remove it using a
clean, lint-free cloth or cotton swab.
Also remove any foreign matter from
the O-ring contact surfaces and from
the port mount thread on the PT-E
series case.
After making sure that the PT-E series
case is completely dry, dismount this
product from the case.
Remove any dust that you can see from
the O-ring, and then pinch the O-ring
with your fingers and rub it along its
length to check for foreign objects such
as sand, damage and cracks.
After removing foreign matter, apply the
provided grease to the O-rings and fit
them into the O-ring grooves.
To apply grease to each O-ring, squeeze
a drop of grease about the size of a
grain onto your finger and lightly rub the
entire circumference of the O-ring to
spread the grease thinly and evenly.
PPO-E05̲En 06.10.24 4:39 PM ページ6
