Olympus OmniScan SX, User Manual

Page: 79 / 86

DMTA-20043-01EN [U8778624], Rev. B, May 2013
List of Figures 71
List of Figures
Figure i-1 Labels location ...................................................................................................... 1
Figure i-2 Membrane vent location ..................................................................................... 4
Figure i-3 Warning symbol on top of the OmniScan SX .................................................. 5
Figure i-4 Warning symbol on battery compartment door ............................................. 6
Figure 2-1 Front panel controls of the OmniScan SX ...................................................... 21
Figure 2-2 Left side panel of the OmniScan SX ................................................................ 25
Figure 2-3 Right side panel of the OmniScan SX ............................................................. 26
Figure 2-4 Top panel of the OmniScan SX (OmniSX-PA1664PR shown) ..................... 27
Figure 2-5 LEMO and phased array probe connectors ................................................... 28
Figure 2-6 Rear panel of the OmniScan SX ....................................................................... 29
Figure 2-7 Fastening holes ................................................................................................... 30
Figure 2-8 Fastening hole location and specifications ..................................................... 31
Figure 2-9 Surface contact requirements ........................................................................... 32
Figure 3-1 The Shut Down button ...................................................................................... 34
Figure 3-2 Saving the setup ................................................................................................. 34
Figure 3-3 Sleep mode selection ......................................................................................... 35
Figure 3-4 The OmniScan SX DC power adaptor plug ................................................... 37
Figure 3-5 Battery charge status ......................................................................................... 38
Figure 3-6 Removing a lithium-ion battery ...................................................................... 40
Figure 3-7 Attaching a ferrite clamp filter to a cable (example shown with the scanner
interface cable) ................................................................................................... 45
Figure 3-8 OmniScan SX connection diagram — ferrite clamp filters .......................... 45
Figure 7-1 Circular DC power jack polarity ..................................................................... 61
Figure 7-2 The scanner interface LEMO connector (pin side) ....................................... 62
Figure 7-3 The scanner interface adaptor LEMO connector (weld side) ...................... 66
Figure 7-4 The scanner interface adaptor DE-15 connector (weld side) ....................... 67