DMTA-20043-01EN [U8778624], Rev. B, May 2013
Basic Operation 35
The “Select a command” message appears (see Figure 3-3 on page 35).
2.
Select
Sleep
.
Figure 3-3 Sleep mode selection
3.
To disable the sleep mode, quickly press the Power key.
The OmniScan SX returns to its previous state (inspection or analysis mode).
3.3
Automatic Start-Up Mode
The OmniScan SX has an automatic start-up mode: auto-boot. Use the auto-boot
mode to remotely start the OmniScan SX unit. When this mode is enabled, you do not
need to press the Power key to start the OmniScan SX. The OmniScan SX starts up
automatically when connected to a DC power adaptor. This mode is disabled by
default.
To activate the auto-boot
1.
Turn off the OmniScan SX unit, remove the batteries, and then disconnect the DC
power adaptor.
2.
Press and hold the Power key.
3.
Connect the OmniScan SX to a DC power adaptor.
4.
Wait for the power indicator light to blink two times, and then release the Power
key.
5.
To deactivate the auto-boot, repeat steps 1 to 4.
3.4
Power Supply Management
The OmniScan SX is a portable instrument that can draw power from either a lithium-
ion battery or a DC power adaptor.
The Sleep button
Summary of Contents for OmniScan SX
