DMTA-20043-01EN [U8778624], Rev. B, May 2013
Connector References 61
7. Connector References
Always use equipment and accessories that meet Olympus specifications. Using
incompatible equipment can result in a malfunction, equipment damage, or injury.
This chapter provides a technical description of the OmniScan SX unit connectors and
adaptor.
The following information is provided for each of the connectors: a brief description,
the manufacturer’s number, the number of the corresponding cable connector, an
illustration, and a table with the signal pinout for the connector.
The following OmniScan SX connectors comply with their respective standards:
•
Scanner interface connector
•
SDHC (memory card slot)
•
Circular DC power jack, 2.5 mm pin diameter, 15 VDC to 18 VDC (see Figure 7-1
on page 61).
Figure 7-1 Circular DC power jack polarity
•
USB
•
VGA
•
R
1
Summary of Contents for OmniScan SX
