DMTA-20043-01EN [U8778624], Rev. B, May 2013
Maintenance 47
4. Maintenance
This chapter describes the basic maintenance that must be performed on the
OmniScan SX unit by operators. The maintenance operations explained below enable
you to keep your instrument in good physical and working condition. By virtue of its
design, the OmniScan SX only requires minimal maintenance. The chapter covers
preventative maintenance and instrument cleaning.
4.1
Preventative Maintenance
The OmniScan SX does not have many moving parts, and therefore only requires
minimal preventative maintenance. Simply perform regular inspections to keep the
OmniScan SX in proper working order.
4.2
Instrument Cleaning
The OmniScan SX external surfaces may be cleaned as needed. This section provides
the appropriate procedure for cleaning the instrument.
4.2.1
Casing Cleaning
To clean the casing
1.
Make sure that the instrument is turned off, and that the power cord is
disconnected.
2.
Disconnect all cables and connectors, and make sure that all external ports on the
OmniScan SX have been covered with their rubber protectors.
3.
Place the cap on the scanner interface connector.
Summary of Contents for OmniScan SX
