DMTA031-01EN, Rev. B, October 2014
Connections and Cables
27
2.7
InterBox Installation
The InterBox can be attached to an Olympus HSMT manual scanner with the supplied
mounting bracket (see Figure 2-12 on page 28). A pair of T-nuts with thumb screws
secures the InterBox to the frame of the scanner (see Figure 2-11 on page 27 and
Figure 2-12 on page 28).
Figure 2-11 The mounting bracket for the HSMT manual scanner
To install or remove the InterBox
1.
Identify a location on the scanner’s frame where the InterBox will be installed.
Ensure that this location allows access to the InterBox’s different connectors
without limiting the scanner’s mobility (see Figure 2-12 on page 28).
2.
Slide the two T-nuts into the frame bar of the scanner.
3.
Move the InterBox assembly along the scanner’s frame bar to the desired location.
T-nut to attach the assembly to the scanner
Mounting bracket
UT-connector side facing up
Summary of Contents for InterBox EIB-T-8-M-15-OM
