DMTA034-01EN, Rev. B, March 2014
Chapter 2
34
To change the frame bar sections
Refer to Figure 2-15 on page 34 for the logical steps.
Figure 2-15 Changing the frame bar sections
1.
Use the respective wing screws to remove all the probe holders (see Figure 2-15
on page 34 [1]).
2.
Use a hexagonal key to remove the two handles and the four rulers from the
frame (see Figure 2-15 on page 34 [2]).
3.
Use the appropriate hexagonal key to loosen and remove the two groups of four
screws on the manifold end of the frame (see Figure 2-15 on page 34 [3]).
4.
Remove manually the two wing screws on the other end of the frame (see
Figure 2-15 on page 34 [4]).
(3) On the manifold end of the
frame, unscrew the 2 groups
of 4 screws.
(4) On the other end of the frame,
remove the 2 wing screws.
(2) Use the proper
hexagonal key or thumb
knobs to remove the two
handles and the four rulers
from the frame.
(1) Use the wing
screws to
remove all the
probe holders.
Summary of Contents for HSMT-Flex
