DMTA017-01EN, Rev. F, August 2016
Chapter 2
22
2.
Slide the wheel assembly to the desired new location (see Figure 2-5 on page 22).
Figure 2
‑
5 Sliding the wheel assembly onto the frame
If necessary, you can temporarily remove the entire wheel assembly, and probe
holders from the frame section in order to reassemble them in the desired new
configuration.
3.
Attach the remaining scanner components in the desired configuration. An
example inspection setup with the frame extended beyond the wheel limits is
shown in Figure 2-6 on page 23.
NOTE
Summary of Contents for HSMT-Compact
