Olympus FV5-LD405, User Manual

Page: 12 / 92

Safety Considerations
I . SAFETY GUIDE
I . 1 - 2 Page
Regarding settings of DIP switches located at back panel of FV5-LDPSU, refer to
VI
1 –
Back panel switch settings.
z
Set this system on robust base.
z
This system generates heat. When installing this system, make it sure that a space of 10cm or more is
provided, left and right of the system, and do not block vent openings.
z
Power cable may be molten when it hits hot place of lamp housing. When installing, make it sure that the
power cable is adequately apart from the lamp housing.
z Never insert a metal piece into vent opening as it may cause failure or electric shock.
z
Do not apply your hand or finger to laser beam that comes from mounting hole of objective lens or objective
tip.
If your hand or finger is exposed to laser beam, it may cause a skin hazard. In addition, never insert a
mirror into light path as the laser beam may come outside and it may enter your eye which is very
dangerous
z Do not set or remove the sample during laser emission (laser scanning). If you set or remove the sample
in such a case, reflection from the sample may enter your eye which is very dangerous. Moreover, do not
look at the sample during laser emission (laser scanning).
z
System performance as well as system safety cannot be guaranteed in case that cover is detached or the
system is disassembled with use of tools. Never disassemble the system.
z
Do not bend or pull fiber excessively. Do not step on the fiber. If the fiber is broken, laser beam may leak
which is very dangerous. In case that such unlikely event occurred, turn power of laser power supply unit
to OFF position immediately and contact our sales office. (when using FV5-LD405 only)
z
Always use the power cord provided by Olympus. If no power cord is provided, please select the proper
power cord by referring to the section “PROPER SELECTION OF THE POWER SUPPLY CORD ”at the
end of this instruction manual.