4
FOCUS PX — Getting Started Guide
Figure 2 The FOCUS PX rear panel
For more details about the FOCUS PX connectors, indicators, and switch, refer to the
FOCUS PX
Phased Array and Conventional Ultrasonic Data Acquisition Instrument User’s Manual
.
To Install a FOCUS PX
1.
Install the FOCUS PX away from heat sources, leaving a minimum clearance of 5 cm (2 in.) on
each side to allow heat dissipation.
To prevent water infiltration, use waterproof cables. Water infiltration could damage the FOCUS PX.
2.
Using a category 5e Ethernet crossover cable, connect the FOCUS PX Ethernet connector to the
network interface card of the inspection computer. The cable supplied with the FOCUS PX is a
category 5e Ethernet crossover cable (Olympus part no. 60ND0001).
When using the FOCUS PX in harsh environments, select an Ethernet cable that has a high resistance
to friction, tensile stress, and torsion.
3.
Install FocusPC on the inspection computer, and then follow the wizard steps to configure the
network card for connection to the FOCUS PX.
Primary DC input
connector
Ethernet connector
Auxiliary DC input connector
I/O connector
SYNCH. IN and SYNCH. OUT
connectors
DIG. OUT ALARMS
connector
