DMTA048-01EN, Rev. C, February 2013
Connections 35
3.
Push the red female metallic quick coupling in the red male
VACUUM
OUTLET
connector until it snaps into place; in this position, the connector is locked.
Figure 2-14
VACUUM
OUTLET
connection
To disconnect the water discharge hose from the pump (CFU05)
1.
Pull back the red ring of the coupling to release the hose’s male connector (see
Figure 2-14 on page 35).
2.
Pull out the hose.
2.4.3
Water Suction Connection
The CFU05 uses suction to remove excess water from the wedges. The recovered
water enters through the
SUCTION
connection (see Figure 2-15 on page 36).
The water
SUCTION
connection uses a plastic quick-coupling mechanism identical to
the one used by the CFU03/CFU05 water supply
OUTLET
connection.
Red color-coded metallic
quick-coupling mechanism
Ring
CFU05 unit
Downloaded from
Summary of Contents for CFU03
