![background image](http://html1.mh-extra.com/html/olympus/camedia-e-20p/camedia-e-20p_basic-manual_734160007.webp)
7
English
2
3
Do not remove
the seal.
If insulation seal
is attached, peel
it off.
1
1
2
Attaching the Strap
Slide one end of the strap through a strap
eyelet on the camera. Slide the end of the strap
through the sleeve and frame on the strap, and
then slide the sleeve completely up to the
eyelet. Pull the strap tight around the frame and
make sure that it does not slip. In the same
way, attach the other end of the strap to the
eyelet on the other side of the camera.
Inserting the batteries
You can use two lithium battery packs (CR-V3),
or four AA (R6) Ni-MH, Ni-Cd, or Alkaline
batteries.
Make sure the power switch is in the OFF
position. Make sure the card access lamp is off.
Underneath the camera, lift the battery
compartment knob and turn it to the open
position. Then, pull out the battery holder.
Place two battery packs (CR-V3 batteries
1
-
3
) or four AA batteries [AA (R6) batteries
1
and
2
] in the holder. Make sure the polarity
markings on the batteries match the markings
as shown and inside the battery holder. Gently
press the batteries into the holder until they
lock in place (AA batteries fit loosely in the
holder even when locked in place).
Insert the holder into the camera, then gently
push in the holder while turning the lock to the
closed position. Finally, fold down the battery
compartment knob.
Battery compartment knob
Battery holder
CR-V3 batteries
AA (R6) batteries