![background image](http://html2.mh-extra.com/html/olympus/camedia-c-7070-wide-zoom/camedia-c-7070-wide-zoom_advanced-manual_4181096177.webp)
Troubleshooting
10
Ap
pen
d
ix
177
The monitor does not turn on.
[MONITOR] is set to
[OFF].
Press
f
several times, and turn on the
monitor.
P. 30
The viewfinder or monitor is hard to see.
The diopter is not
adjusted properly.
Adjust the diopter so that the AF target mark
is clearly visible.
P. 29
There is condensation*
inside the camera.
Turn the camera off and wait until it dries
before turning it on again.
–
The brightness of the
monitor is not adjusted
properly.
Select [
s
] in [MODE MENU] and adjust the
brightness.
P. 130
The monitor is exposed
to direct sunlight.
Block the sunlight with your hand or use the
viewfinder.
–
Vertical lines appear on
the monitor screen
during shooting.
Aiming the camera at a bright subject in
sunlight may cause vertical lines to appear
on the screen. This is not a malfunction.
–
The date recorded with the image data is wrong.
The date/time is not set. Set the date/time. The clock adjustment is
not factory-preset.
P. 123
The camera has been
left with the battery
removed.
If the camera is left for 3 days with the battery
removed, the date/time setting is canceled.
Set the date/time again.
P. 123
The settings are returned to the factory default settings when the camera is turned
off.
[ALL RESET] is set to [ON]. Set [ALL RESET] to [OFF] in [MODE MENU].
P. 120
The picture is out of focus.
The subject was too
close.
Move further away from the subject. To take
pictures closer than 20 cm (7.9") with the
zoom in the maximum WIDE position, use the
super macro mode.
P. 46
The subject is dark.
Set [AF ILLUMINATOR] to [ON] in the mode
menu.
P. 66
Auto focus is not
possible.
Use manual focus or focus lock to focus on
the subject and then shoot.
P. 31,
67
There is condensation*
on the lens.
Turn the camera off and wait until it dries
before turning it on again.
–
Possible cause
Corrective action
Ref.
page