7
Overview of Device
The fi gures on Page 2 illustrate the warning lamp in
detail� Familiarise yourself with the warning lamp before
starting to use the warning lamp�
1
Loop
2
12 LEDs (fl ashing scenarios)
3
Operating mode button
4
3 LEDs (torch)
5
Protective rubber casing
6
Hook (fold-out)
7
Magnet
8
Screws for battery compartment
9
Battery compartment
Safety Instructions
Read the operating manual carefully and
always proceed as described� Keep the
operating manual in a safe place for future
reference� Avoid any personal injury to yourself and
others by paying attention to the following information!
W
ArninG
!
Risk of suffocation! Keep out of
reach of children! Keep the packaging and
protective foils as well as batteries out of reach
of children� Keep the warning lamp out of reach of
children� Small children can swallow small parts or
batteries� If a battery is swallowed, seek medical
attention immediately�
c
Aution
!
Risk of explosion through improper
replacement or removal of the batteries! Only
replace the batteries with ones approved by the
manufacturer and dispose of batteries according to the
applicable regulations�
c
Aution
!
Risk of injury to the retina� The
LEDs in the warning lamp are very bright and
could damage the eyes� Never look directly into
the beam produced by the warning lamp LEDs when
switched on�
Intended Use
The WL9 LED warning lamp with torch, subsequently
referred to as the warning lamp, is designed to identify
specifi c areas. Please note that the warning lamp is
no substitute for legally applicable safety measures�
Always observe national laws and regulations�
Any other use is considered unintended use� Unauthor-
ised modifi cations or reconstructions are not permitted.
Never attempt to complete any repair work yourself�
Package Contents
Check the package contents of the warning lamp
carefully before putting the warning lamp into operation�
If anything is missing or damaged, please contact our
Service department�
■
WL9 LED warning lamp with torch
■
Operating manual
Inserting the Batteries
Only use batteries which comply with the specifi cations
in Chapter “Technical Data”�
1
Loosen the screws on
the rear side using a
suitable screwdriver�
2
Insert three appropri-
ate batteries in the
battery compartment�
Pay attention to correct
polarity�
3
Replace the battery
compartment cover
and tighten the screws
with an appropriate screwdriver�
G
