Olympia TBL 1300 Combo, Operating Instructions Manual

Page: 25 / 128

25
6.2.3 Clearing jammed lamination foil
The device is equipped with a JAM RELEASE sliding switch to clear foil
jams quickly.
Proceed as follows if the lamination foil jams:
1. Switch the device off: Press the POWER button until the POWER LED
goes out.
2. Slide the JAM RELEASE switch to the right as far as possible.
3. Hold the laminator firmly and pull the lamination foil together with the
document to be laminated out of the laminator's infeed.
4. Slide the JAM RELEASE switch back to the left.
5. Clean the transport rollers of any deposits and residual adhesive by
inserting a folded piece of paper in the laminator infeed, refer to Chapter
"Cleaning the transport rollers".
Note: If foil jams occur repeatedly or jammed foil cannot be removed
from the laminator, please contact our hotline (refer to Chapter
"Guarantee").
6.3 Thermal binder
6.3.1 Thermal binding
1. Ensure that the device is switched on, refer to Section "Switching the
device on and off".
2. Press the Preheating button to start the warm-up process.
3. The Bind/Counter LED flashes red when the device is warming up. The
correct operating temperature is reached after about 3 minutes and the
Bind/Counter LED lights up green continually. An acoustic signal also
indicates that the device is ready for thermal binding.
4. Insert the sheets of paper in the thermal binding cover.
Note: Pay attention to the maximum binding capacity, refer to Chapter
"Technical Data".
5. Pull out the tray on the rear side of the device (cooling device) to enable
the thermal binding cover to be inserted in the binder infeed slot.
6. Guide the thermal binding cover, with the closed side at the bottom, from
the top in the binding infeed slot. An integrated clamping mechanism
holds the paper perpendicular.
7. Press the Thermal Binding button to start the binding process.