Quick Reference
CM 1810
plus
plus
plus
plus
Cash Register
(13)
Olympia
08.2002
Page 1
Rights to make technical changes reserved!
This Quick Reference manual only provides basic information.
More detailed information is available in the Operating Instructions.
Insert paper roll
Raise the printer lid as illustrated. Use paper rolls with a width of 57mm and maximum diameter of 70mm. Do not use
recycled paper. This causes quicker printer wear. Prepare the paper roll for insertion. Remove the first layer and cut the
end of the roll straight. This prevents paper jamming in the printer mechanism. Insert the cut end of the roll in the printer
and press
A
until approx. 10 cm has been fed in. Depending on the method of use, feed the paper past the tear-off
edge on the printer lid or onto the take-up reel. Finally, close the printer lid.
CM
18
10
OL
YMPIA
Paper reel
The paper reel is required when the journal paper (special two-layered paper roll with carbon copy facility is required) or
the receipt paper should be rolled onto it.
1.
Open the printer lid.
2.
Remove the paper reel.
3.
Thread the end of the journal paper in the slit in the paper reel.
4.
Insert the paper reel in the hollows provided for it.
5.
In order to remove the journal paper after it has been rolled up on the reel, remove
the paper reel and pull the journal paper roll off.
6.
Reinsert the paper reel.
7.
Close the printer lid.
Change ribbon
Note: Only use black/red ribbons. The black side must be at the top.
1. Open the printer lid.
2. Lift the left and right ribbon spools up and out of the guides.
3. Insert new ribbon rolls on the guides.
4. Insert the new ribbon cassette in the printer so that the ribbon is positioned between
the digit roll and paper. The outer edge must rest on the side ribbon guides. Tighten
the ribbon a little.
5. Insert the paper roll.
6. Close the printer lid.
Key-operated switch
The key must be set to position REG for normal operation (registration).
Off
Registration
(normal operation)
X-reports (without
memory deletion)
Z-reports (with
memory deletion)
Programming
Training
Note: Loss of data and jamming of the cash register are possible in operating of Z or P modes! Only use these
modes when you are familiar with programming and operating the machine.
