Olympia 4030152031306, Manual

Page: 18 / 72

18
c
aution
! Risk of burns due to hot machine surface! During hot laminating, the
machine surface heats up. Do not touch the machine surface during the laminating
operation. Wait a few minutes after laminating until the laminator has cooled down
before you touch the device surface.
5
Feed the prepared laminating pouch with the closed side fi rst, keeping it straight, into the
infeed of the laminator. The laminator automatically draws in the laminating pouch and ejects
it on the output side. The pouch is very hot and soft when ejected following lamination.
Cold Lamination
For cold lamination, the laminating pouch is coated with a special adhesive. Unlike hot lamina-
tion, cold lamination bonds the foil through pressure, not heat. Cold lamination is suitable for
non-permanent sealing. The cold laminating pouch can usually be removed from the laminated
material without leaving any residues.
1
Switch the On/Off switch to on
2
Set the function switch to coLd
3
Remove the protective foil from the laminating pouch.
4
Place the material to be laminated inside the laminat-
ing pouch. For an optimal lamination result, leave an
all-round spacing of 3 to 5 mm from the edges of the
pouch.
If the material to be laminated is not in a
standard paper format, also place an insert
inside the laminating pouch that corresponds
with the paper format of the laminating pouch.
Position the document to be laminated at the front edge of the closed end of the
laminating pouch.
5
Feed the prepared laminating pouch with the closed side fi rst, keeping it straight, into the
infeed of the laminator. The laminator automatically draws in the laminating pouches and
ejects it on the output side.
3 - 5 mm