Page 6 from
6
WARRANTY
Olympia Electronics guarantees the quality, condition and operation of the goods. The period of
warranty is specified in the official catalogue of Olympia Electronics and also in the technical leaflet,
which accompanies each product. This warranty ceases to exist if the buyer does not follow the
technical instructions included in official documents given by Olympia Electronics or if the buyer
modifies the goods provided or has any repairs or re-setting done by a third party, unless Olympia
Electronics has fully agreed to them in writing.
Products that have been damaged can be returned to
the premises of our company for repair or replacement, as long as the warranty period is valid.
Olympia Electronics reserves the right to repair or to replace the returned goods and to or not charge
the buyer depending on the reason of defection. Olympia Electronics reserves the right to charge or
not the buyer the transportation cost.
HEAD OFFICE
72
nd
km
.
O
.
N
.
R
.
Thessaloniki-Katerini
P
.
C
. 60300
P.O.
Box 06
Ε
ginio Pierias
Greece
www.olympia-electronics.gr
[email protected]
Battery replacement process
(*)
Maintained operation: The luminaire lights its
illumination source, when it is powered by the
mains power supply or not
.
It can be done only by a competent person and after the mains interruption
.
1 Unfasten the two side cover screws and remove the plastic cap (with the indications) by sliding
it gently to the right.
2 Remove the old battery. Install the new one and place the connector as shown
ο
n the picture.
3 Refit the plastic cap (with the indications) by sliding it gently to the left and fasten the removed
screws in step 1.
WARNING
!!
Use a maximum torque of
0,
9
Ν
m
to tighten the screws
.
ΝΟΤΕ!! In case of battery replacement the used battery must be replaced with a new one of
the same type, by the manufacturer or by a competent person.
2
1
NOTE: LED= Light Emitting Diode
LABELING EXPLANATION:
X:
Self contained
1:
Maintained
(*)
A:
Including test device
E:
With non-replaceable lamp(s) and/or battery
F:
Automatic test gear complying with IEC
61347-2-7 denoted EL-T
G:
Internally illuminated
90:
1.5 hour duration
180:
3 hours duration
Note!! If a module will be used (except the fault
relay module), then t
he installer should fill in
, on
the specification label,
the letter
s
B C
.
X
1
9 0
A
E F G
923064003_09_00
2
