ELECTRICAL CONNECTIONS (after the mains interruption)
1
2
3
4
5
6
7
Unfasten the two side cover screws and remove the plastic
cap by sliding it gently. Install
the gasket and make a hole in
the center by using a small screwdriver. Pass the round
cable through the gasket.
Connect the mains cables to the respective terminal block
.
Ν
for neutral
,
L for live wire,
L1 for the maintained
operation and the for ground connection
.
The L
1
wire
can be connected to an external switch to control the
maintained or non maintained operation of the luminaire
.
For permanent maintained operation use two wires to power
the luminaire,
Ν
for neutral and L for live wire, and link the L
and
L1. The
A
and
B
contacts are used only if an optional
module is connected.Refer to the modules manual for more
information regarding connection.
The battery is not connected. See the section “Battery
replacement process” to access the battery compartment
and connect the battery.
ATTENTION!!
Make sure that the ground cable is attached
to the respective ground connector.
Replace the removed
parts in the previous steps.
SURFACE MOUNTING ON A WALL (single sided)
Install the included plastic bracket on the wall (figure 1).
Remove the aluminum bracket from the luminaire and use
the two supplied mounting screws to install the aluminum
bracket to the plastic bracket (figure 2). Slide the luminaire to
the aluminum bracket and use the bolt on the center
(*)
, to
stabilize the luminaire (figure 2).
CEILING MOUNTING (double sided)
Remove the aluminum bracket from the luminaire and install
it with the included spacers, screws and plugs in the ceiling
(page 3). Slide the luminaire to the aluminum bracket and
use the bolt on the center
(*)
, to stabilize the luminaire (figure
4).
Power on the device at the end of the installation
.
NOTE!! After finishing the installation you must power
the luminaire at least for 24 hours for battery charging to
perform the nominal autonomy.
INSTALLATION INSTRUCTIONS
(*)
First, hand tighten it and then,
use pliers to tighten it little bit
more (not all the way).
LED MODULE CHARACTERISTICS
Manufacturer
Model Number
Voltage Range
Connections
Nominal Power
Temperature (tc)
Olympia Electronics S.A
45 °C max. across the board
50 °C max. across the board
45 °C max. across the board
Non reversible connection between main pcb and led module
14 - 16.5VDC
0204185
2405185
2705185
7.2W
4.5W
11.7W
LLB-26/90-LLB-26/180
LLB-40/90-LLB-40/180
LLB-64/90-LLB-64/180
Page 3 from
6
N
L
L1
B
A
Ground
connector
2
1
Cable
entry
Screws
L1
L
L1
N
N
L
PE
L1
L
L1
N
N
L
PE
Maintained
operation
(Default)
Non-maintained
operation
Luminaire
terminals
Luminaire
terminals
Connection Diagramms
923064003_09_00
2
