Page
2
from
5
923037016_09_001
LAMP TESTING
AUTOMATIC DURATION TEST
Erasing errors is accomplished with a prolonged
pressing of the TEST button (>5 sec) when the unit
is connected to the mains power supply. The fault
indicated with the indicator LAMP FAULT / BATT.
FAULT will be erased. If the cause of the fault has
not been restored (i.e burned lamp) then the
indicator will light again. If the fault was caused by
a low emergency duration and you erase the error
then this will be indicated again during the next
duration test after 6 months. In this case (for
duration errors) it is vital to replace the battery
before erasing the error (the error is automatically
erased if the mains power and the battery are
disconnected).
AUTOMATIC EMERGENCY CIRCUIT TEST
The unit automatically tests the emergency circuit
every 15 days (if the battery and mains power are
connected) . During this test the lamps are turned
ON for 3 seconds using the batteries. In some
cases this function might not be acceptable (i.e in
cases this function might not be acceptable (i.e in
cinema theaters) so the installer must take this
into account during the installation.
This test is conducted every 6 months by
simulating a power failure, if the battery and mains
power supply are connected. The unit lights the
lamps using the charged battery and counts the
time until the stated duration. If the lamps are ON
during the end of the test then the unit is restored
to its normal operation (lamps OFF and battery
charging). If the lamps go OFF before the end of
the test then the unit is restored to its normal
operation but the LAMP FAULT / BATT. FAULT
indicator is lit to show that there is a problem with
the battery and that the battery must be replaced.
Let it be noted that this duration test is also done
during every long power failure. If the power
failure lasts for a long time and the luminaire has
entered the BATTERY CUTOFF mode and the
duration measured is not correct then the fault
indicator will light when the power is restored.
ERASING ERRORS
The luminaire tests the good condition of the
lamps in emergency mode and warns the user for
probable malfunction. If a lamp is found faulty then
the LAMP FAULT indicator starts to blink. To verify
which lamp is faulty use the TEST button. If the
faulty lamp is replaced then the error is
automatically restored and the indicator is turned
OFF.
The WL luminaire models have the ability to
communicate over the air with Olympia’s control
panels for wireless emergency luminaires. The
luminaires can also communicate with a
PC/laptop through a gateway (Ethernet, Wi-Fi,
USB). For more information, please refer to
Wireless Emergency Lighting guides, available
on the company’s website.
procedure must be done only by qualified
Wireless communication
WARNING !!!
1. Every test, installation or maintenance
personnel.
3. The replacement of the battery and the
light source must be done using parts of
2. The unit must be connected to the mains
accordingly.
the same type, by the manufacturer or by
a competent person.
4. If the luminaire must be isolated from the
mains power supply for more than 2
months then the batteries must be
disconnected by removing the battery
power supply using a line fuse rated
connectors.
5.
I
s not allowed to discard batteries in to
t i
common trash bins, they must be
discarded only
in battery recycling
points. Do not incinerate.
Battery replacement
It can be done only by a competent person
and after the mains interruption.
1.
Follow the step 2
o
f the installation
procedure.
2.
Disconnect the
cables
and remove the
old battery.
3.
Connect the new battery with the same
type (step
3
of the installation procedure)
and place it in the position
of the old
one.
4.
Follow the step
6
of the installation
procedure and power the device.