6.3. TEST.
System check , call point and programming names
Insert the technical code (1111) and using the
FAULT EVENTS
key scroll to the
indication
TEST.
Press
ENTER
and the Display shows the indication
------
.
In this mode we can test the system and check if the call points which are mounted
on every room are operating and corresponding to the numbers that we have
programmed for every room.
For this test to be conducted two people are required. Also some form of
communication between them is also required (E.g. Wireless radio , intercom).
One person goes from room to room and presses the call points. The other person
verifies that all the call points are operating and that that there is a correspondence
between the call point and the displayed value.
When the call point is pressed, the Display shows the number of the zones - room
(e.g. P 1) and the room name which has been programmed (e.g. 101) .
At the end of the process press successively the
ESC
key so as to exit the
programming procedure.
Page 12 from 18
7. SIGNAL NUMERATOR PANEL OPERATION MODE.
This operation mode is for the user and is very simple.
When the mounting and programming process has finished and the system has been
tested and is operating then the user can do the following operations.
7.1. Starting position operation.
The system is ready to accept the calls of the zones - rooms and on the control
keyboard - unit we have the following indications.
The Display shows the indication
----
and the
POWER
LED is lighted (green led)
.
7.2. Calling from a call point.
If a call point is pressed in any room - zone, the keyboard shows the room number
which was programmed to correspond to the specific call point. The buzzer also
sounds.
7.3. Calling from more than one call points.
If two or more call points are pressed then the keyboard successively shows the
numbers from the call points that were pressed and the
SIGNAL
indication led lights
to indicate that we have multiple calls. The buzzer also sounds.
7.4. Resetting/cancelling indications and calls.
To reset/cancel calls press the
ON - OFF BUZZER / HELP
key and the call that is
shown will be reset/canceled.
921746000_09_003
