22.
Attach
2I & 2J - Horizontal Wall Cleats
to Wall Extender
bottom framing and Rear Wall top framing so that cleat is flush with
extender framing. There are two short cleats and one long cleat.
Alternate alignment of screws, so half screw into Wall Extender
Framing and half into Rear Wall Top Framing. Use
3 - 1 1/4” Screws
per short cleat and
6 - 1 1/4” Screws
on the long cleat.
Parts
2I
- Horizontal Wall Cleat - Long
(3/4” x 3 1/2” x 84”)
x 1
2J
- Horizontal Wall Cleats - Short
(3/4” x 3 1/2” x 26 1/4”)
x 2
Hardware
S2
- 1 1/4” Screws
x 12 total
23.
Attach
2EE
- Interior Door Header
as shown above. Align with top
framing of front walls. Attach with
4 - 2 1/2” Screws.
To complete Wall Section
,
attach bottom 2x3 wall plates to plywood floor with
2 - 2 1/2” Screws
per wall section. Prior to securing, make sure wall panels
are aligned correctly on the floor. Refer to
Step 9.
Wall siding should overhang
floor while 2x3 wall plates should sit
flush with floor.
Hardware
S1
- 2 1/2” Screws
x 32 total
Bottom W
all
Optional
- Caulking seams will help
prevent moisture from entering at
seam. Caulking not included in kit.
Parts
2EE
- Interior Door Header
(1 1/2” x 3” x 66 1/2”)
x 1
Advice:
Use Interior Door Header
to confirm doorway opening is
66 1/2” wide at top and bottom.
66 1/2”
Toll Free 1-888-658-1658 www.outdoorlivingtoday.com [email protected]
Page 16
