7
between the pre-amp and the power-amp. Connect your external FX gear input to
the Little Hill SEND jack, and the FX output to the Little Hill RETURN jack. The effect
loop can be bypassed by the switch between the SEND and RETURN jacks, or by the
FOOT SWITCH.
The FX loop has separate levels for send and return levels. Adjust the send level to
match the connected devices and then adjust the return level for unity gain.
You can also use the effects loop as booster. Set the SEND level at 5 o’clock (max)
and the RETURN level at 13 o’clock or more. Now turn the effects loop on and you
will have an increased volume. This is very useful for soloing.
Note that you should set the SEND level as high as possible and the RETURN level as
low as possible to minimize the noise.
SEND LEVEL
Output level to external devices.
SEND
Output jack to external device. This is the output from the pre-amp.
BYPASS
FX loop bypass switch. This is a true bypass circuit.
RETURN
Input jack from external device. This is the power-amp input.
RETURN LEVEL
Input level from external devices.
FOOT SWITCH
Connect the supplied footswitch to this jack. Set the channel switch at the front to
CH1 and the FX loop bypass switch to ACTIVE. If you don’t do this, the footswitch
will not work.
LOUDSPEAKERS
There are three speaker outputs available on the rear panel. They are labeled
according to the intended speaker cabinet impedance. Use a cable between the amp
and the cabinet made for speaker purposes.
WARNING, although the Little Hill has three speaker outputs connect only
one
speaker cabinet with the correct impedance, at a time.
POWER ON
Amps main power switch.
MAINS INPUT with MAIN FUSE
Connect the included power cord in accordance with the voltage and frequency ratings
listed on the rear panel of the amplifier.
