22
•
Remove the heater from the packaging using the
feet and lay it onto a soft surface (the Styrofoam
sheet can be used if necessary).
fig.6
•
Turn the heater upright to stand on its feet.
Make certain that the painted surfaces are not
scratched!
Remember that the heater can easily tilt and fall
forward! If necessary, lean it against the wall!
•
Open the heater:
Take off the plastic covering caps left and right.
Remove the screws.
fig.7
Pull the front panel at the bottom 10cm outwards
from the heater and push upwards to remove.
Take out the Styrofoam strip between the inside
and outside front panels.
fig.8
Remove the fixing screws from the top of the right
and left side panels.
Tilt out the side panels 3cm and push backwards
to remove.
fig.9
