Step 2
Cut out the Cabinet Front
Cut the front of the cabinet using the dimensions shown below.
NOTE
Measurement “C” must be greater than the height of the sink.
(240mm).
Step 3
Cut and Install the Benchtop
Reversible Fronts
The Farmhouse Sink has the peculiarity of having
two different fronts: one front has ‘sharp’ corners, with a radius of
18mm and a 32mm top edge to suit the style of modern and
contemporary environments. The opposite front has more rounded
corners with a 40mm radius, and a wider top edge of 40mm. These
softer lines are the ideal combination for country kitchens, or those
kitchens with a more classic or retro design.
Before cutting the benchtop opening, choose
the direction the sink will face.
The following diagrams show the measurements to be used to cut
the benchtop hole, according to the direction chosen.
Step 4
Seal the Sink with the Benchtop
Apply a thin bead of only ‘neutral cure’ silicone sealant where the sink
meets the benchtop and cabinet. Use of an ‘acetic cure’ silicone can
irreparably damage the sink. Immediately wipe away excess sealant.
NB: Cut dimensions are intended for standard depth benchtops (648mm).
INSTALL WITH 32mm FRONT EDGE (SHARP)
767mm
520mm
52mm
143.5mm
407mm
187mm
CABINET 610mm
461mm
240mm
R20mm
40mm
32mm
767mm
520mm
61mm
151mm
407mm
187mm
CABINET 610mm
461mm
R20mm
240mm
INSTALLATION STEPS
INSTALL WITH 40mm FRONT EDGE (ROUND)
C
822mm
240mm
838mm
The front of the cabinet needs to be
cut-out allowing the sink to protrude.
Page 3 of 4
