Oliver MODEL 777-NT, User'S Operating And Instruction Manual, Page: 22 / 44

777-NT Variety Slicer
0777S20039 6-9
The new belt can be installed by reversing the removal procedure. Refer to the
“Tightening the Belt” section to adjust the tension on the drive belt.
Adjusting the Blade Frames When Slices Vary in Thickness
Remove the discharge table from the slicer. Loosen, but, do not remove the two locking
cams which secure the blade frame to the swing shaft. Remove the plastic plug over the
set screw in the fixed collar, see below. Using an allen wrench, loosen, do not remove
the set screw in the fixed collar. Using a ruler, (15” maximum), measure the distance
between the blades. Gently tap the collar with a small mallet either to the right or left
until the distances between the blades are equal. When satisfied with the location
tighten the fixed collar’s set screw and replace the plastic plug. Lastly tighten the two
locking cams which secure the blade frame.