Oliver Legacy Elite 2017, Owner'S Manual

Page: 77 / 122

68
Monitor Panel
The monitor panel allows you to check the approximate liquid levels in the
fresh water, gray and black holding tanks, along with the charge on the
batteries. Refer to manufactures manual for further assistance.
Fresh Water Tank
When an outside source of water is unavailable, water can be drawn from
the fresh water storage tank through the use of the 12-volt pump system. The
tank is filled through a standard pressurized water hose connection located at
the rear area next to the city water inlet. Standard capacity of the fresh water
tank is 32.5 gallons.
To fill the fresh water tank:
1. Remove the cap from the fresh water inlet.
2. Attach a fresh water hose to an outside water source.
3. Attach the other end to the Oliver fresh water inlet.
4. Turn on water source; fill until water starts to run from the fresh water
overflow, which is located on the opposite side, between the aluminum steps
and the refrigerator vent.
5. When the tank is filled, replace the water cap.
Note: Always fill the tank with clean drinkable water from a known safe
source. Make sure to cap the water inlet when the tank is filled. Also, always
fill system with a hose that you know is clean and is used only for this
purpose.
When traveling, you may want to drain the tank, or keep the quantity of
water in it to a minimum. This reduces the total weight of the Oliver for
travel. When draining the tank make sure that the water pump has been
turned off. The fresh water tank drain valve is concealed beneath the rear
passenger compartment. Turning the water valve 1⁄4 turn can drain water in
the tank. The water will be released below the trailer near the rear bumper.
Do not forget to close the valve after emptying the fresh water tank.