Oliver 5018, Owner'S Manual

Page: 23 / 52

20
FILTER/REGULATOR/LUBRICATOR UNIT
1.
PRESSURE GAUGE
The pressure for the air system is shown on this pressure gauge. Working air
pressure can be adjusted by turning the pressure regulator located on the
filter bowl. Turn it clock-wisely for increasing pressure. Turn counter clock-
wisely for decreasing pressure. Lift the regulator knob before setting pressure.
Push it down to fix the pressure setting after the pressure has been adjusted.
The working air pressure should be set at 5-6kg/cm2.
2.
LUBRICATION BOWL
Periodically check to make sure that there is an adequate amount of oil in the
lubrication bowl. If necessary, fill oil into the lubrication bowl to 80% of the bowl
capacity to ensure that the air circuit is properly lubricated.
3.
FILTER BOWL
Always remember that the moisture contained in air will condense and collect in
the filter bowl. The accumulated water in the filter bowl needs to be released
when the water level reaches a certain level. To release water simply pull back
the AIR ON/OFF CONTROL COLLAR on the quick air connector.