Splitter and Blade Guard Assembly
1. Disconnect saw from power source.
2. Insert the blade guard support rod into hole
A as shown in figure 17.
3. Remove the table insert then secure the
blade guard support rod with lock washer (1)
and nut (2) as shown in figure 18.
4. Lower the blade guard onto the front and
rear brackets using the provided hex bolt
and washer to secure into place as in figure
19.
5. Adjust the rear support bracket so that the
rear of the blade guard is in line with the
front of the blade guard and the blade itself.
Figure 17
Figure 18
Figure 19
11
