Oliver 4045, Owner'S Manual, Page: 10 / 16

Calibrating the Digital Angle Readout
1. Place a square on the table as shown in
Figure 11 then turn the saw tilt wheel until the
blade comes to 90 degree.
2.
Push and hold the 0
°
set button as shown in
Figure 14 until the display stops blinking. The 0
°
is now set.
3. Tilt the blade to 45 degrees as shown in
Figure 12. Push and hold the
45
°
 set button as
shown in Figure 15 until the display stops
blinking. At this point the angle display is
calibrated.
Figure 12
Figure 14
Figure 15
10