Oliver 1808-D, User'S Operation

Page: 14 / 59

1808-D
1808S20055 5-2
The speed control knob is used to adjust the machine speed by turning clockwise to a
higher number for higher speed and counter clockwise to a lower number for lower
speed.
Before you are ready to run production, turn the Heated Roll “ON/OFF” ( I/O) switch to
the “ON” ( I ) position. This will supply power to the heater elements in the heat seal roll
to bring it up to temperature. You should turn the power on approximately 20 minutes
prior to the time you want to begin production. This will give the heat seal roll ample
time to heat up. At the end of the day, turn the “ON/OFF” ( I/O ) switch to the “OFF” ( O )
position.
Be sure infeed gate is in place, discharge cover is closed, and E-stop is
released for heat seal roll to be energized. Otherwise heat seal roll temperature
will not rise and therefore will not seal properly.
Continued