1 ) Use iron only for its intended use.
2 ) To protect against a risk of electric shock, do not immerse the iron in water or other liquids.
3 ) The iron should always be turned to “Off” before plugging or unplugging from the outlet. Never tug cord to
disconnect from the outlet; instead, grasp plug and pull to disconnect.
4 ) Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around
iron when storing.
5 ) Always disconnect iron from electrical outlet when filling with water or emptying and when not in use.
6 ) Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of
electric shock, do not disassemble the iron. Take it to a qualified serviceman for examination and repair. Incorrect
reassembly can cause a risk of electric shock when the iron is used.
7 ) Do not allow children to use iron. Close supervision is necessary for any appliance being used near children. Do
not leave iron unattended while connected or on an ironing board.
8 ) Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron
upside down – there may be hot water in the reservoir.
9 ) If the LED flashes orange (not red or green), the iron is not operating normally. Disconnect from the power
supply and have the iron serviced by qualified service personnel.
IMPORTANT SAFETY INSTRUCTIONS
When using your iron, basic safety precautions should always be followed, including the following:
Read all instructions before using this product.
SPECIAL INSTRUCTIONS
1 ) The iron must be used on a stable surface. When placing the iron on a stand or resting surface, make sure the
stand or surface is stable.
2 ) Oliso irons are high wattage appliances: The EU version is 2000-2400W at 220-240V. The US and Canada
versions are 1600W at 120V for models TG1050, 1800W at 125V for models TG1100, TG1250, and TG1600. To avoid a
circuit overload, do not operate another high wattage appliance on the same circuit.
3 ) If an extension cord is absolutely necessary, a 15A cord should be used. Cords rated for less amperage may
overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.
4) This iron uses hot steam!
5) Never direct fill the iron from a water tap while the iron is plugged into a power source.
6) FOR HOUSEHOLD USE ONLY
SAVE THESE INSTRUCTIONS
SAVE THESE INSTRUCTIONS
