8
PROBLEM
POSSIBLE CAUSE
SOLUTION
The”
Add Water
”
indicator lights up
1. Lack of water
2. Filter screen plug at the
bottom of the water tank
3. The induction needle is not
in the middle of the hole
1. Stop making ice, add
water, press “ON / OFF”Key
Restart ice making.
2. Clean.
3. Adjust the position of the
induction needle
“
ICE FULL
”indicator
is on.
1. There is too much ice in the
ice basket.
2. The ice full sensor is bad,
no ice water is full of light.
3. Water infiltrates into the
induction lamp
1. Stop making ice, add
water, press “ON / OFF”Key
restarts ice making
2. Clean.
3. Adjust the position of the
induction needle.
Ice full light flicker
The ice shovel was stuck
If the shovel is stuck in the ice,
take the ice out. Otherwise,
please contact customer
service.
The ice is linked
together
The ice making cycle is too
long
Stop the ice maker and
restart it when the ice blocks
melt. Select the small size ice
cube selection.
Water temperature in inner
tank is too low
Replace the water in the
water tank, the water
temperature is best between
46°F and 89°F.
Ice making cycle is
normal, but no ice
formed.
Exorbitant ambient
temperature or water
temperature
Please make ice when the
ambient temperature is
below 89°F and give a certain
amount of cold water to the
water tank.
Leakage of refrigeration
system
Contact customer service
Clogging of the refrigeration
system
Contact customer service
TROUBLESHOOTING
